Difference between revisions of "XBee Interface Board"
Line 29: | Line 29: | ||
##1k resistor |
##1k resistor |
||
##LE-33 low dropout voltage regulator (Digikey 497-4258-1-ND) |
##LE-33 low dropout voltage regulator (Digikey 497-4258-1-ND) |
||
##2.2uF tantalum capacitor (Digikey 399-3536-ND) |
##2.2uF non-polarized tantalum capacitor (Digikey 399-3536-ND) |
||
<br clear="all"> |
<br clear="all"> |
||
Revision as of 09:25, 5 April 2008
The pins on the XBee radio (Digikey XB24-AWI-001-ND) have a pitch of 2 mm, which makes it impossible to plug into a standard 0.1 inch pitch breadboard. The XBee Interface Board allows one to plug the XBee into a breadboard or directly into a FTDI USB-RS232 cable.
Traxmaker Source Files and Gerber Files
The Traxmaker source files and Gerber files can be downloaded here:
Media:XBee_Interface_Board_Traxmaker_Gerber.zip
Media:XBee_Interface_Board_Traxmaker_Gerber_array.zip You can order an array of boards and cut them yourself.
PCB
This is the PCB. If the PCB has fibers sticking out of the edge, scrape or file them off. These are glass fibers, and can stick into your finger like a splinter.
Components
Not all of the components are required. The voltage regulator and capacitor go together; if you don't need the regulator, you won't need the capacitor either.
- PCB
- 2x 10 pos. 2 mm pitch socket (Digikey S5751-10-ND)
- 2x 10 pos. header pin (broken off Digikey S1011E-36-ND)
- low current LED (Digikey 160-1086-ND)
- 6 pos. 90 degree header pin (broken off Digikey S1111E-36-ND)
- 1k resistor
- LE-33 low dropout voltage regulator (Digikey 497-4258-1-ND)
- 2.2uF non-polarized tantalum capacitor (Digikey 399-3536-ND)
Populating the Board
2mm Socket
Make sure the sockets go in straight. If they are crooked, the XBee radio will not be able to plug in. Using tape to hold the socket in place while soldering may make it easier to solder.
Voltage Regulator and Capacitor
The capacitor is required for the low-dropout capacitor to be stable. Tantalum or electrolytic capacitors are best. Ceramic capacitors happen to work with the LE-33 regulator, but may not work with other low-dropout regulators.
Tantalum capacitors are polarized, so note the polarization. The positive terminal will have a small '+' sign on the package.
LED
The LED illuminates when the board is powered. It won't hurt to leave it out if it isn't needed. The 1k resistor is just there to limit the current going through the LED, so if LED is left out, the 1k resistor should be left out too.
The LED is polarized. LEDs generally have a flat side which indicates the ground; the flat side corresponds to the side with the line (as opposed to the triangle) on the board's legend
6 pos. 90 Degree Header
The 90 degree header allows the board to be plugged into a breadboard vertically or plugged into an FTDI USB-RS232 cable.
10 pos. Straight Headers
Putting header pins on the interface board allows it to be plugged into a breadboard like a DIP package. The pins should be soldered from the top.