Difference between revisions of "NU32: What is in the NU32 Kit"
From Mech
Jump to navigationJump to searchNickMarchuk (talk | contribs) |
NickMarchuk (talk | contribs) |
||
Line 88: | Line 88: | ||
</table> |
</table> |
||
⚫ | |||
⚫ | |||
<table border="1"> |
<table border="1"> |
Revision as of 16:50, 27 December 2011
The NU32 kit contains everything necessary to begin programming the NU32 board. Check to make sure your kit contains the items listed below.
Components in the kit:
Picture | Description | Link |
---|---|---|
NU32 in 2 breadboards | NU32: Software to Install, NU32: Starting a New Project and Putting it on the NU32 | |
1 m USB cable, A male to mini B male | Datasheet | |
6V wall power supply, 1A, 2.1mm ID x 5.5mm OD, 6W, center positive. Model xxx from CUI Inc. | Datasheet | |
LCD, 16x2, using xxx communication | Nokia 5110, Datasheet, NU32v2: Nokia 5110 LCD | |
10 LED array, green. | Datasheet | |
10 pin, 9 resistor, 330 Ohm common cathode bus. Dot indicates common pin. For use with the LED array. | Datasheet | |
Momentary NO pushbutton. | Datasheet | |
Resistors | A few of the following 1/4W resistors: 100k ohm, 10k ohm, 330 ohm, 100 ohm | no link |
Capacitors | A few of the following capacitors: 0.01uF, | no link |
Potentiometers | A few of the following 1/4W potentiometers: 10k ohm, | no link |
LEDs | Red super bright 5mm LED | no link |
Phototransistors | SFH 310 visible spectrum phototransistor | Datasheet |
Components from previous courses:
Picture | Description | Link |
---|---|---|
Wire strippers, for 30, 28, 26, 24, 22, and 20 AWG wire. Can also be used as pliers and to cut wire. Do not try to cut anything else with these, they will get dull | Sparkfun wire strippers | |
6 colors of ~6" sections of 22 AWG solid core wire (red, white, yellow, green, black, blue) | no link | |
Small multimeter, xxx. | Multimeter, Datasheet | |
Extra breadboard, 830 tie points. | 830 T/P Breadboard |