Difference between revisions of "Unipolar Stepper Motor Driver Circuit"
m |
|||
Line 1: | Line 1: | ||
This page presents a circuit for driving high-power unipolar stepper motors. Here you will find all the information needed to make your own. This circuit allows step-level control and can be easily modified for other modes of operation. |
This page presents a circuit for driving high-power unipolar stepper motors. Here you will find all the information needed to make your own. This circuit allows step-level control and can be easily modified for other modes of operation. |
||
===What you need=== |
===What you need=== |
||
Line 36: | Line 36: | ||
| [[image:stepper wire colors.png]] |
| [[image:stepper wire colors.png]] |
||
|} |
|} |
||
===xPC Code=== |
|||
The program below is the simplest program for controlling the circuit above. The Pulse block dictates the speed of the stepper and the constant (1 or 0) sets the direction. |
|||
[[image:xpc stepper controller.png|center]] |
|||
===Alternative=== |
|||
An alternative method for building this circuit is using the [[media:DS2003.pdf|DS2003]]) darlington array. It is lower power, but will save some space. |
Revision as of 15:19, 27 July 2006
This page presents a circuit for driving high-power unipolar stepper motors. Here you will find all the information needed to make your own. This circuit allows step-level control and can be easily modified for other modes of operation.
What you need
- Power
- +5v (low power)
- +12v (high power)
- ICs
- Discrete Components
- (4x) 2N6045 NPN Darlington Power Transistor
- (8x) 1N4001 Diodes
- (2x) 3.3kOhm Resistors
- Other
- PC104 or High-Level Controller
- 12v Unipolar Stepper Motor
Circuit Schematic and Photo
The L297 has several inputs that can be generated by a PC/104 stack or other controller. This circuit allows you to control each step, in full-step mode. Meaning: You can tell it to move one step in either direction (of course you can make it move fast and it will continuously rotate). The two inputs are a direction and a pulse. In the next section you will find a program to control this using xPC.
Here is the CircuitMaker file: Unipolar Stepper Driver Circuit
You may find the following diagrams useful when constructing this circuit:
xPC Code
The program below is the simplest program for controlling the circuit above. The Pulse block dictates the speed of the stepper and the constant (1 or 0) sets the direction.
Alternative
An alternative method for building this circuit is using the DS2003) darlington array. It is lower power, but will save some space.