Difference between revisions of "Attaching to a shaft"
From Mech
Jump to navigationJump to search| Line 8: | Line 8: | ||
<br clear=all> |
<br clear=all> |
||
* Epoxy |
* Epoxy |
||
Some companies that provide shaft couplings: |
|||
* [http://www.fennerdrives.com Fenner Drives] |
|||
* [http://www.mcmaster.com McMaster-Carr] (split collars, trantorque bushings) |
|||
* [http://www.sdp-si.com Stock Drive Products] (shaftloc and other couplings) |
|||
* [http://www.lovejoy-inc.com Lovejoy] |
|||
* [http://www.ringfeder.com/ Ringfeder] |
|||
Revision as of 13:42, 20 June 2010
There are many ways to attach to a shaft (e.g., a motor shaft). Below are a few examples.
- Press fit or interference fit; see also the wikipedia page (note: be careful not to apply axial press forces large enough to damage the motor; the shaft should be supported to avoid this)
- Set screws
- Split clamp
- Keyway
- Epoxy
Some companies that provide shaft couplings:
- Fenner Drives
- McMaster-Carr (split collars, trantorque bushings)
- Stock Drive Products (shaftloc and other couplings)
- Lovejoy
- Ringfeder
