Difference between revisions of "Attaching to a shaft"
From Mech
Jump to navigationJump to search| Line 3: | Line 3: | ||
* [http://www.eminebea.com/content/html/en/engineering/bearings/fitting.shtml Press fit or interference fit] (note: be careful not to apply press forces large enough to break the motor) |
* [http://www.eminebea.com/content/html/en/engineering/bearings/fitting.shtml Press fit or interference fit] (note: be careful not to apply press forces large enough to break the motor) |
||
* [http://en.wikipedia.org/wiki/Set_screw Set screws] |
* [http://en.wikipedia.org/wiki/Set_screw Set screws] |
||
* |
* Split clamp [[Image:split-clamp.gif]] |
||
<br clear=all> |
<br clear=all> |
||
* [http:// Keyway] |
* [http:// Keyway] |
||
Revision as of 11:29, 14 February 2009
There are many ways to attach to a shaft (e.g., a motor shaft). Below are a few examples.
- Press fit or interference fit (note: be careful not to apply press forces large enough to break the motor)
- Set screws
- Split clamp
- [http:// Keyway]
