Difference between revisions of "Attaching to a shaft"

From Mech
Jump to navigationJump to search
Line 1: Line 1:
There are many ways to attach to a shaft (e.g., a motor shaft). Below are a few examples.
There are many ways to attach to a shaft (e.g., a motor shaft). Below are a few examples.


* [http://www.eminebea.com/content/html/en/engineering/bearings/fitting.shtml Press fit or interference fit] (note: be careful not to apply press forces large enough to damage the motor)
* [http://www.nmbtc.com/bearings/engineering/fitting.html Press fit or interference fit] (see also the [http://en.wikipedia.org/wiki/Interference_fit wikipedia page] (note: be careful not to apply axial press forces large enough to damage the motor; the shaft should be supported to avoid this)
* [http://en.wikipedia.org/wiki/Set_screw Set screws]
* [http://en.wikipedia.org/wiki/Set_screw Set screws]
* Split clamp [[Image:split-clamp.gif]]
* Split clamp [[Image:split-clamp.gif]]

Revision as of 14:37, 20 June 2010

There are many ways to attach to a shaft (e.g., a motor shaft). Below are a few examples.


  • Keyway Keyway.jpg


  • Epoxy