View source for C Example: Bi-Directional PWM Motor Control

__TOC__
==Code==
Program to run a motor bidirectionally at varying speeds depending
on the position of a potentiometer.

First include header file with definitions for specific PIC.
Set fuses.  HS is type of external clock, low voltage protection
(LVP) is off, and the watchdog timer (WDT) is off.
External clock frequency of 20 MHz is specified.

   #include <18F4520.h>
   #fuses HS,NOWDT,NOPROTECT,NOLVP
   #use delay(clock=20000000)

Introduce the variables to be used in the main program.

   int read;
   int readlow;
   int readhigh;

Begin main body of program.

   void main() {

Setup the CCP1 and CCP2 to be PWM outputs. Also set the timer
to be used for PWM.

      setup_ccp1(CCP_PWM);
      setup_ccp2(CCP_PWM);
      setup_timer_2(T2_DIV_BY_1, 255, 1);

Setup analog input, and which analog channel is active.

      setup_adc_ports(AN0_ANALOG);
      setup_adc(ADC_CLOCK_INTERNAL);
      set_adc_channel(0);

Setup an infinite loop, using a while statement.

      while(TRUE) {

Read the analog input and define "readhigh" and "readlow"
as functions of "read". Note that the value of "readhigh"
varies from 0 to 255 when the potentiometer is between
140 and 255, and "readlow" behaves similarly.

         read = read_adc();
         readlow = (120-read)*2.125;
         readhigh = (read-140)*2.217;

Check the value of "read", and set the duty cycle of each PWM
output signal accordingly.  The H-bridge circuit used requires
two inputs (the two PWM outputs of the 18F4520) to control the
direction and speed of the driven motor.

         if (read<120){
            set_pwm1_duty(readlow);
            set_pwm2_duty(0);}
         else if (read>140){
            set_pwm1_duty(0);
            set_pwm2_duty(readhigh);}
         else {
            set_pwm1_duty(0);
            set_pwm2_duty(0);}
     }
   }
==Associated Circuitry==