View source for PIC32MX: High-speed Wireless Communication

== Original Assignment ==

'''Do not erase this section!'''

Your assignment is to create the circuit and code that allows two PIC32s to use wireless communication at high speeds using the Transceiver nRF24L01+ Module with Chip Antenna from [http://www.sparkfun.com/commerce/product_info.php?products_id=691 Sparkfun].

Read up on the nRF24L01+ Module commands and create functions to allow a PIC32 to initialize and send and receive data.

Test your code by sending 1000 bytes of data from one PIC32 to the other and echo the data back. How long does this transmission take? How far can you separate the PIC32s before the transmission is unreliable?

=== Final Project Goal ===

Transmit a byte of data (e.g. a character) from one PIC32/nRF24L01+ board to the other board, and display the received character on a PC screen. 

== Overview ==

This wiki describes how to wire a [http://www.sparkfun.com/commerce/product_info.php?products_id=691 nRF24L01+ chip] ("wireless chip") to the transmitting PIC32 board ("transmitter") and receiving PIC32 board ("receiver"), and includes annotated code describing the functions that facilitate the wireless communication.

== Circuit ==

Include a schematic and give any part numbers.  A photo of your circuit is OK, but not as a replacement for a schematic.

== Code ==

Where possible, make it a single piece of well-commented cut-and-pastable code, or at least make each function that way, so others can easily copy it.  Most comments should be in the code itself; outside the code (on the wiki) should only be explanatory comments that are too cumbersome to include in the code.