PIC Microcontrollers with C18 Compiler

PIC Microcontroller

The microcontroller used for this project is the PIC18F4431 made by Microchip. This is an 8-bit microcontroller with motor PWM generators, a quadrature encoder interface (QEI), and other "peripherals". The microcontroller uses an external 40MHz oscillator.

The microcontroller controls two wheel motors with PWM driving external H-bridges. The H-bridges draw their power directly from the batteries, not regulated power.

Each of the wheels also has a quadrature encoder. The left wheel encoder is connected to the PIC's QEI via a schmitt trigger buffer. The right wheel encoder is wired to a U.S. Digital LS7183 chip (because the PIC only has 1 QEI) which outputs pulses on one of two pins, depending on whether the wheel is spinning backwards or forwards. The two pins are then each connected to a counter on the PIC, which keeps track of the number of pulses. The location of the wheel can be determined by subtracting the reverse-pulse counter from the forward-pulse counter.

The PIC is interfaced with the XBee modem via the RS-232 serial interface.

Troubleshooting

• If MPLAB has trouble connecting with the ICD2, open the Device Manager (Control panel>System>Hardware>Device Manager) and disable then re-enable the ICD2. Also be sure that you followed in installation instructions in the manual when you installed the ICD2.