Difference between revisions of "PIC Microcontrollers with C18 Compiler"
| Line 13: | Line 13: | ||
You must now add a linker script to your project. Make sure '''View>Project''' is checked, then right-click on '''Linker Scripts''' in the project panel and click on '''Add Files...'''. The linker scripts are in folder '''MCC18\lkr'''. Find the file that corresponds to your microcontroller (p18f4431 (or p18f4431i if you are using the ICD2 programmer) for the PIC18F4431 microcontroller). |
You must now add a linker script to your project. Make sure '''View>Project''' is checked, then right-click on '''Linker Scripts''' in the project panel and click on '''Add Files...'''. The linker scripts are in folder '''MCC18\lkr'''. Find the file that corresponds to your microcontroller (p18f4431 (or p18f4431i if you are using the ICD2 programmer) for the PIC18F4431 microcontroller). |
||
====Recommended Reading==== |
|||
===Troubleshooting=== |
===Troubleshooting=== |
||
Revision as of 16:34, 6 July 2007
PIC Microcontroller
The microcontroller used for this project is the PIC18F4431 made by Microchip. This is an 8-bit microcontroller with motor PWM generators, a quadrature encoder interface (QEI), and other "peripherals". The microcontroller uses an external 40MHz oscillator.
The microcontroller controls two wheel motors with PWM driving external H-bridges. The H-bridges draw their power directly from the batteries, not regulated power.
Each of the wheels also has a quadrature encoder. The left wheel encoder is connected to the PIC's QEI via a schmitt trigger buffer. The right wheel encoder is wired to a U.S. Digital LS7183 chip (because the PIC only has 1 QEI) which outputs pulses on one of two pins, depending on whether the wheel is spinning backwards or forwards. The two pins are then each connected to a counter on the PIC, which keeps track of the number of pulses. The location of the wheel can be determined by subtracting the reverse-pulse counter from the forward-pulse counter.
The PIC is interfaced with the XBee modem via the RS-232 serial interface.
Programming the PIC
For this project, Microchip's free C18 compiler was used with the MPLAB IDE. If you are using the ICD2 programmer, be sure to follow the installation instructions carefully, or Windows may attempt to install the wrong drivers. After installing both MPLAB and C18, create a new project with the project wizard. Follow the prompts, and you should end up with an empty project if you did not add any existing files.
You must now add a linker script to your project. Make sure View>Project is checked, then right-click on Linker Scripts in the project panel and click on Add Files.... The linker scripts are in folder MCC18\lkr. Find the file that corresponds to your microcontroller (p18f4431 (or p18f4431i if you are using the ICD2 programmer) for the PIC18F4431 microcontroller).
Recommended Reading
Troubleshooting
- If MPLAB has trouble connecting with the ICD2, open the Device Manager (Control panel>System>Hardware>Device Manager) and disable then re-enable the ICD2. Also be sure that you followed in installation instructions in the manual when you installed the ICD2.
