PIC32MX: SPI Communication between PIC32s

Original Assignment

Do not erase this section!

Your assignment is to create code that allows two PIC32 boards to communicate with each other via SPI.

Overview

SPI or Serial Peripheral Interface is a communication method that was once used to connect devices such as printers, cameras, scanners, etc. to a desktop computer. This function has largely been taken over by USB, but SPI can still be a useful communication tool for some applications. SPI runs using a master/slave set-up and can run in full duplex mode, meaning that signals can be transmitted between the master and the slave simultaneously. There is no standard communication protocol for SPI.

SPI is still used to control some peripheral devices and has some advantages over I2C (another type of serial data communication). SPI can communicate at much higher data rates than I2C. Furthermore, when multiple slaves are present, SPI requires no addressing to differentiate between these slaves. Compared to parallel buses, SPI has the additional benefit of requiring only simple wiring.

Peripheral devices that still use SPI:

• Converters (ADC and DAC)

• Memories (EEPROM and FLASH)

• Real Time Clocks (RTC)

• Sensors (temperature, pressure, etc.)

• Others (signal mixer, potentiometer, LCD controller, UART, CAN controller, USB controller, amplifier)

Basic Operation

SPI requires four lines, and is therefore often termed the “four wire” serial bus. These four lines are described in the table below.

Line	Name	Description
SCLK	Serial Clock	Output from master
MOSI/SIMO	Master Output, Slave Input	Output from master
MISO/SOMI	Master Input, Slave Output	Output from slave
SS	Slave Select	Output from master (active low)

The master, as its name suggests, controls all communication. By controlling the clock, the master decides when data is sent and received. Within each clock cycle a full duplex communication is carried out; each side sends and receives one bit of information. Because there is no standard communication protocol, the master can either send data or both send and receive data, depending on the needs of the application. Likewise, the slave can either receive data or both receive and send data back to the master.

Using the “Slave Select” line, the master chooses which slave with which to communicate. Note that more than one slave may be selected, simply by applying a logic low to the desired SS lines, as illustrated in the schematic diagram shown above. If a given slave is not selected (its SS is high) it disregards signals sent by the master.

References

SPI Background(www.totalphase.com)

SPI Wikipedia Article (www.wikipedia.org)

More Information (www.mct.net)

Circuit

Include a schematic and give any part numbers. A photo of your circuit is OK, but not as a replacement for a schematic.

Code

Where possible, make it a single piece of well-commented cut-and-pastable code, or at least make each function that way, so others can easily copy it. Most comments should be in the code itself; outside the code (on the wiki) should only be explanatory comments that are too cumbersome to include in the code.