Flexure Characterization and Design

From Mech
Revision as of 15:15, 10 June 2009 by Philip Dames (talk | contribs)
Jump to navigationJump to search

Overview

Flexures are deformable solid bodies used to connect elements in a mechanical system. This flexibility allows for greater freedom of motion of the parts relative to each other than a rigid joint does, but at the cost of complicating the dynamics of the system. As one can imagine, it is important to know the properties of the flexures in order to predict and control the behavior of a system. This project is primarily focused on the flexures used in the PPOD projects in LIMS which are used to connect the linear actuators to the table. In this case the flexures allow the table to move in all six degrees of freedom (three translational and three rotational) which the use of rigid joints would not allow. The goals of this project are to be able to test the performance of the existing flexures and to use this information to design new ones to improve the performance of the PPOD.

Current Design

The flexures currently on the PPOD are made of a 1/4" Tygon tubing glued to aluminum mounts.

Hardware

Transfer Function Fitting

Until now, only a simple approximation has been used to describe the flexures when modeling the system. In reality, a flexure will have a mass, damping, and spring matrix associated with it that maps its motion to the forces it applies.

Here is a vector of forces and moments and is a vector of coordinates. This leads to a transfer function from input acceleration to output force given by:

For all 36 combinations

Results

Next Steps