Data logging with an EEPROM

From Mech
Revision as of 00:15, 11 February 2009 by Neil Tiwari (Talk | contribs)
Jump to: navigation, search


Original Assignment

Your task is to use the PIC to log data from an analog input on an EEPROM, and after the data collection is over, to send the data back from the EEPROM to a PC running matlab. Use an interrupt service routine to read an analog input and write the value to an external EEPROM using I2C. After reading in a fixed number of samples, perhaps 1,000 or 10,000, the program should send the data back to a matlab program via an RS-232 link. The logged data should then be plotted by matlab.

You should decrease the sample time until the ISR does not successfully complete. What is the fastest rate at which an analog input can be read and stored to the external EEPROM? Try this for an analog input configured for both 8-bit (1 byte of data stored on the EEPROM) and 10-bit (2 bytes of data stored on the EEPROM). How much data can you store on the EEPROM?

As an alternative, you can avoid the use of an ISR and simply read and store the data as fast as you can in a loop.

As a test input, use a triangle wave signal from the function generator between 1 and 4 V, and plot the data in matlab.

See Interfacing to External EEPROM, PIC RS232, and Serial communication with Matlab.




Further Reading

Personal tools