Difference between revisions of "Circuit diagram for wave generator"
From Mech
Jump to navigationJump to search| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Image:SquareTriangle555.gif|right]] |
[[Image:SquareTriangle555.gif|right]] |
||
The circuit shown produces a pretty good square wave (10 V peak-to-peak) able to drive a low impedance load, and a slightly curved triangle wave of lower amplitude, and only able to drive a high |
The circuit shown produces a pretty good square wave (10 V peak-to-peak) able to drive a low impedance load, and a slightly curved triangle wave of lower amplitude, and only able to drive a high impedance load. |
||
The 555 "timer" chip in the figure is shown with its pins in the actual DIP8 layout (pin 1 is upper left) |
The 555 "timer" chip in the figure is shown with its pins in the actual DIP8 layout (pin 1 is upper left) |
||
The time constant is T = R1 * C1, which here would be 100uS. I measure a repetition rate of 3KHz. |
|||
Latest revision as of 17:46, 18 January 2008
The circuit shown produces a pretty good square wave (10 V peak-to-peak) able to drive a low impedance load, and a slightly curved triangle wave of lower amplitude, and only able to drive a high impedance load.
The 555 "timer" chip in the figure is shown with its pins in the actual DIP8 layout (pin 1 is upper left)
The time constant is T = R1 * C1, which here would be 100uS. I measure a repetition rate of 3KHz.
