Basic Linear Circuits Review

Common Measurements and Units

In the representations of measurements such as charge, voltage, current, and power, an uppercase letter (C, V, I, P) implies that it is constant, and a lowercase letter (c,v,i,p) implies that it is time-variant.

Charge (Coulomb)

Protons are positive charges, and electrons are negative charges. Charges in motion is a current. The SI unit for charge is the coulomb, which is equivalent to the amount of charge the current (in amperes) delivers in an amount of time (in seconds). 1 coulomb is equal to 1 ampere multiplied by 1 second.

1C=(1A)(1s)

Electric Poential (Volt)

The volt is a unit for the relative potential energy between two points or two electrodes. The ground is usually assigned a voltage of 0, and used as a reference. Current tends to flow from high voltage to low voltage. 1 volt is equal to 1 Joule per Coulomb.

1V=(1J)/(1C)

Current (Ampere)

An electric current represents electric charges flowing through a conductor. By tradition, the current is modeled as a flow of positive charges, even though it was later discovered that current is in fact a flow of negative charages. The ampere, or amp, is the unit for the current, and is determined by the rate of flow of the charges. 1 amp is equal to 1 coulomb per second.

1A=(1C)/(1s)

Common Electrical Components

Symbols, Variables, and Units

	symbol	variable	units
current source	File:Current source symbol.jpg	I	Ampere (A)
voltage source	File:Voltage source round symbol.jpg or File:Voltage source batt symbol.jpg	V	Volt (V)
resistor	File:Resistor symbol.jpg	R	Ohm ($\Omega$)
capacitor	File:Capacitor symbol.jpg or File:Capacitor polarized symbol.jpg (polarized)	C	Farad (F)
Inductor	File:Inductor symbol.jpg	L	Henry (H)