MediaWiki API result
This is the HTML representation of the JSON format. HTML is good for debugging, but is unsuitable for application use.
Specify the format parameter to change the output format. To see the non-HTML representation of the JSON format, set format=json.
See the complete documentation, or the API help for more information.
{
"batchcomplete": "",
"continue": {
"sroffset": 10,
"continue": "-||"
},
"query": {
"searchinfo": {
"totalhits": 30
},
"search": [
{
"ns": 0,
"title": "Potentiometers",
"pageid": 1522,
"size": 3765,
"wordcount": 636,
"snippet": "...a linear or slide pot), and others have a "logarithmic" or "audio taper," <span class='searchmatch'>meaning</span> that the amount of resistance changes logarithmically with the motion. Thi\n",
"timestamp": "2006-08-10T17:07:18Z"
},
{
"ns": 0,
"title": "Gear Motor",
"pageid": 2446,
"size": 1250,
"wordcount": 212,
"snippet": "In the case of a small transmission ratio N, the unit may be backdrivable, <span class='searchmatch'>meaning</span> you can turn the output shaft, perhaps by hand, at angular velocity w and c\n",
"timestamp": "2006-12-27T15:09:25Z"
},
{
"ns": 0,
"title": "Using LEDs & IREDs",
"pageid": 2650,
"size": 1924,
"wordcount": 338,
"snippet": "LEDs and IREDs are diodes, <span class='searchmatch'>meaning</span> they conduct in their forward direction only. If their maximum reverse vol\n",
"timestamp": "2007-12-27T20:43:15Z"
},
{
"ns": 0,
"title": "NatNetLinux",
"pageid": 5271,
"size": 870,
"wordcount": 145,
"snippet": "* The 'latency' field is a float, <span class='searchmatch'>meaning</span> it has about 7 digits of precision. Since it starts at 0 when Motive starts\n",
"timestamp": "2014-03-07T21:30:03Z"
},
{
"ns": 0,
"title": "Linear Amplifier Motor Driver",
"pageid": 1815,
"size": 2108,
"wordcount": 345,
"snippet": "...In this control mode, the driving transistors are nearly always saturated, <span class='searchmatch'>meaning</span> little power dissipated as heat by the transistors.\n",
"timestamp": "2006-10-20T23:44:34Z"
},
{
"ns": 0,
"title": "SPI - Serial Peripheral Interface - on the PIC",
"pageid": 3223,
"size": 2027,
"wordcount": 334,
"snippet": "...mputer. SPI runs as a master slave set-up and can run in full duplex mode, <span class='searchmatch'>meaning</span> that signals from the master to the slave and vis versa can be transferred \n",
"timestamp": "2008-12-18T01:21:22Z"
},
{
"ns": 0,
"title": "Phase-Sensitive Detection",
"pageid": 3181,
"size": 6055,
"wordcount": 951,
"snippet": "...the output is \u2018<math>input \\times 1</math>\u2019, and when the switch is OFF (<span class='searchmatch'>meaning</span> connected to the ground), the output is \u2018<math>input \\times 0</math>\u2019.\n",
"timestamp": "2009-01-07T01:59:29Z"
},
{
"ns": 0,
"title": "Waveform Generation with AD9833",
"pageid": 3222,
"size": 7757,
"wordcount": 1310,
"snippet": "...10), the last 14 bits are the value of the write, and do not have the same <span class='searchmatch'>meaning</span> as specified in the table. Similarly, if a phase register is being written\n",
"timestamp": "2008-12-18T02:12:15Z"
},
{
"ns": 0,
"title": "Waveform Generation with AD9833, and SPI",
"pageid": 3173,
"size": 7757,
"wordcount": 1310,
"snippet": "...10), the last 14 bits are the value of the write, and do not have the same <span class='searchmatch'>meaning</span> as specified in the table. Similarly, if a phase register is being written\n",
"timestamp": "2008-12-18T00:31:39Z"
},
{
"ns": 0,
"title": "Unipolar Stepper Motor Driver Circuit",
"pageid": 2121,
"size": 2166,
"wordcount": 330,
"snippet": "...roller. This circuit allows you to control each step, in full-step mode. <span class='searchmatch'>Meaning</span>: You can tell it to move one step in either direction (of course you can ma\n",
"timestamp": "2006-08-04T16:50:55Z"
}
]
}
}